UCW TYPE – Glassware/ components

cGMP WASHING EQUIPMENT FOR GLASSWARES/ COMPONENTS

UCW TYPE – Glassware/ components

cGMP WASHING EQUIPMENT FOR GLASSWARES/ COMPONENTS

The UCW machines are specifically designed to wash, chemically and/or thermally disinfect and dry parts and instruments, such as glassware, filling machine components and plastic containers.

SOLIDS AND SEMI-SOLIDS

WATER + DETERGENTS OR SOLVENTS + AIR

20°C – 120°C

Process features
Additional information

Standard and custom programmes for all needs. The machine process is developed by our Automation department in compliance with current codes/standards and the type of product being processed. Products go from dirty to being ready to be sterilised, by means of a pre-wash, chemical and/or clean steam wash, rinse with PW or WFI (recirculation or direct flow) and a final HEPA 13-filtered hot air drying phase. Whilst also keeping the water TOC level, conductivity and pH level under control. During the product wash phase, chemicals and/or clean steam can be injected by means of a precise and reliable system in order to improve the machine’s cleaning efficiency.

Single-wall square or rectangular cross-section chamber made of 316L or 316Ti stainless steel.
Innovative central pumping/draining sump made of 316L or 316Ti stainless steel.
Piping and air ducts made entirely of 316L stainless steel with sanitary fittings (tri-clamp ferrules and hygienic flanges).
3D (dead leg)-compliant piping system with minimum 3-degree incline of the pipes towards the floor drain.
Any surfaces in contact with the product are mechanically polished to a roughness level lower than 0.35 micron.
Rounded internal chamber corners to facilitate a perfect cleaning.
Manual folding chamber doors or vertical/horizontal automatic sliding doors (door structure made of 316L or 316Ti stainless steel with a HST tempered glass inspection window).
Double-lip chamber seal made of silicone rubber.
Components and tools made of 316L/316Ti stainless steel and elastomers in compliance with FDA 21 CFR, Part 177.
The chamber pipes, components and instruments are suitably insulated with high-tech material.
Area separation by means of a 304 or 316L/316Ti stainless steel “bio-seal” frame.
Brand-new design that connects the utilities to the internal cart, complete with an automatic locking and release system (100% seal guaranteed).
Manual or fully automated ergonomic product loading and unloading solutions.
Floor-level or elevated loading solutions.